A hot tub beats most people who take it on themselves, and it is not the lifting that does it. The tub is hard wired into the house, it holds four or five hundred gallons that cannot legally go just anywhere, and the shell will not fit in a pickup even after you empty it. Here is the real order of operations, and the steps to not do alone.
The short version
- The electrical comes first, and a licensed electrician does it. Not you, not us.
- The water has to be dechlorinated, and where it goes after that is your town’s call.
- The shell has to be cut down to pieces two people can carry through a gate.
- The frame and motors are scrap metal, the one part of this that goes somewhere useful.
- No town bulk program I checked takes a hot tub. They are built for a couch.
Step one: the electrical, which is not yours to do
Almost every backyard spa here is hard wired on its own 240 volt circuit, with a shutoff box a few feet from the tub. Flipping the breaker is not disconnecting it. The feed still has to be pulled and made safe at both ends, and that box has to come off the post.
That work belongs to a licensed electrician. Danvers puts it as plainly as a town can: on the Electrical page for its Electrical Inspector, Mark Fialkowski, the town says all electrical work must be completed by a licensed electrician, checked September 15, 2026. Salem’s page on installing a pool, spa or hot tub says a licensed electrician must pull a permit from the City Electrical Department if there is any electrical work to be done, checked September 15, 2026.
The electrician also tells the town: M.G.L. c. 143, s. 3L says no person shall install for hire any electrical wiring or fixtures subject to that section without giving notice to the inspector of wires, checked September 15, 2026. Whether your town wants the same paperwork to take a circuit out is a question for your wiring inspector, so call and ask. I will not tell you to just flip the breaker. Same line on above-ground pool removal: we do not do electrical disconnects on any job.
Step two: the water, and where it can legally go
A full tub is the heaviest thing in the yard and the most regulated. Chlorine and bromine are the reason.
Stop the chemicals first
The clearest guide is the permit your town’s storm drains run under. At part 1.4, the Massachusetts Small MS4 General Permit lists de-chlorinated swimming pool discharges among the non-stormwater discharges it allows, and says elsewhere they must be dechlorinated and otherwise free from pollutants, read September 15, 2026. Chlorinated water is not on that list.
Dechlorinating is mostly waiting. Wellesley’s DPW publishes the method on its pool and spa drainage sheet: let the water sit in the sun 5 to 10 days without adding chlorine, or use a dechlorination additive, then test it with a pool kit, read September 15, 2026. That is Wellesley’s guidance, not a statewide rule, but the chemistry does not change by town.
Where it may go is a town question
In Salem, the ordinance on water and sewers says at section 46-192 that stormwater and all other unpolluted drainage shall go to sewers specifically designated as storm sewers, or to a natural outlet approved by the director of public services, read September 15, 2026. The operative word is unpolluted, and a tub you shocked last week is not.
Marblehead is blunter. Its stormwater bylaw at section 195-7B bans discharging any pollutant or non-stormwater discharge into any storm sewer system, watercourse or waters of the commonwealth, read September 15, 2026, with exemptions left to regulations the enforcement authority adopts. The town decides, not you.
So: dechlorinate, then ask your own DPW where it may go. A slow release onto your lawn, well back from the street, is what most guidance points at. The street itself is the wrong answer everywhere.
Hot tub removal is the one service where we will drain it for you if it is still full, so tell us when you book. That is not our pool policy, where the water has to be gone before we pull up. Do not read one page and assume the other.
Step three: cutting the shell down
An empty shell still weighs several hundred pounds and is wider than any gate on a normal lot. It comes apart where it sits: cabinet panels off, insulation out, then the acrylic and fiberglass shell cut into sections two people can carry. No crane, no truck in the yard, no torn up lawn.
This is the step where a reciprocating saw and a free Saturday turn into a hospital visit. The shell is sharp along every cut. If you do it yourself, work with another adult, wear eye protection, and never cut over a tub with water in it.
Step four: the metal is the one part that pays
Under the cabinet there is a steel or aluminum frame, pump motors, a heater assembly and copper. Metal is not optional here. Ferrous and non-ferrous metals sit on MassDEP’s waste disposal ban list, read September 15, 2026, so it cannot ride to disposal with the rest of the load. We pull it out on site and it goes to Turner Inc in Lynn rather than a transfer station, the same route as any scrap metal pickup. It is the one line on this job that moves in your favor.
Step five: the shell, which is disposal only
Here is the honest part. I could not find a facility that publishes a recycling route for an acrylic or fiberglass spa shell, and it is not on the MassDEP ban list either, so nothing requires it to be diverted. It is refuse, priced by weight.
Marblehead’s 2026 tipping fee notice shows what that costs on a scale: furniture, rugs, cleanouts and construction material all cross the weigh and pay at $320 per ton, effective January 1, 2026, read September 15, 2026. Salem’s page on construction and demolition debris tells residents to call a contractor, because it is not picked up with regular trash, read September 15, 2026.
No town bulk program takes a hot tub
I checked four before writing that line, on September 15, 2026, and none lists one.
- Salem defines a bulk item as a large item such as furniture, carpet or doors that does not fit in your curbside cart, at $20 per item.
- Marblehead has no curbside bulk pickup at all. The Board of Health’s curbside collection regulations define bulk waste as furniture, mattresses and appliances too large for the town carts, and say they must be taken to the transfer station and paid for.
- Beverly allows one bulky item a week, scheduled directly with Casella, at costs that vary with the size of the item.
- Danvers charges $50 at the Transfer Station for televisions, monitors, appliances, furniture and tires, and states that no construction and demolition materials or masonry debris will be accepted.
A hot tub is not a couch and not an appliance. It is light demolition, which is why it lands with us instead of the town truck.
What it costs
Same model as everything else: volume, plus weight, plus access. The minimum is $120, and anything larger is priced by volume, at about $80 to $100 per cubic yard, with heavy material priced by weight instead. A hot tub always lands well above the minimum because of the labor in it. You get the price in person before we cut a single panel, and it does not go up.
Access is the part people forget. A tub on a second floor deck, behind one narrow gate, or up a slope is a different job than one on a slab by the driveway. If there is a deck coming out with it, or a shed in the same corner of the yard, say so and we will quote both on one visit. The rest of this category sits on the light demolition and hauling page, and these numbers come off our pricing page.
Most of our hot tub work is in the towns with the backyards for it: Marblehead, Beverly, Danvers, Topsfield, Boxford, Hamilton, Wenham, Lynnfield, North Reading and Ipswich.
Getting a number
Text photos to 978-915-3399: one wide shot of the tub, one of the gate or path we would carry through. Tell me whether it is still full and whether the power is off.
We are brother owned, licensed and insured: $2M general liability, a $1M umbrella policy and $1M commercial auto, USDOT 8843043. Work is often same-day, though I will not promise it as a guarantee.
Call or text 978-915-3399 and a real person on our team picks up, never an AI and never a call center. How our hot tub removals run is the short version of the job itself.